Gallery Home

Thom's Photo Album :: Trips, RoadStar, Tats, and more

Home :: Login
Album list :: Last uploads :: Last comments :: Most viewed :: Top rated :: My Favorites :: Search
Home > RoadStar Mods

K&N Air Filter


kn1.jpg

This is a universal air filter from K&N.

5 files, last one added on May 31, 2008
floorboard extentions


right-side-installed.jpg

Installing the Lighting Performance Floorboard extentions.
These extentions move the floorboards forward 3 inches and tilt the heel down about a half inch

5 files, last one added on Jun 26, 2008
Raised Brake Pedal


3.jpg

A simple mod that raises the bottom of the brake pedal from 2 1/2 inches to 4 inches above the floorboard. I placed two washers that measured 1/4 in. thick total between the brake assembly and floorboard bracket on the studs that mount the assembly to the bracket. Then I cut a small rubber hose to the length of the brake pedal stop and a rubber gas line the same. I sliced them both open, placed the smaller hose in the larger one and slide them over the pedal stop.

6 files, last one added on Jul 13, 2008
speedo


05032010_010.jpg

8 files, last one added on May 03, 2010
Rear Turn Signals


oldoff.jpg

6 files, last one added on May 05, 2010
 

5 albums on 1 page(s)

Random files - RoadStar Mods
05032010_010.jpg
 night shot 254 viewsI tried to reduce the glare from the flash
4.jpg
 71 views2 washers, 1/4 in. thick total.
05032010_003.jpg
 old face off29 viewsThe old face plate of the instrument housing
kn5.jpg
 81 views
oldoff.jpg
 ready to mount13 viewsOff with the old, ready for the new
oldlights.jpg
 front view22 viewsWell a view from the back I guess
kn4.jpg
 82 views
05032010_008.jpg
 night shot 141 viewsNew face is on and looking good.
Taken at night

Last additions - RoadStar Mods
oldoff.jpg
 ready to mount13 viewsOff with the old, ready for the newMay 05, 2010
oldlights.jpg
 front view22 viewsWell a view from the back I guessMay 05, 2010
oldbackside.jpg
 rear view13 viewsrear view of old set upMay 05, 2010
done2.jpg
 done221 viewsNew turns and plate holder on the bikeMay 05, 2010
behindplate.jpg
 Behind the plate20 viewsThis is where the wires are stashed in the old set up.May 05, 2010
done1.jpg
 Done122 viewsNew turns and plate holder on the bikeMay 05, 2010
05032010_010.jpg
 night shot 254 viewsI tried to reduce the glare from the flashMay 03, 2010
05032010_008.jpg
 night shot 141 viewsNew face is on and looking good.
Taken at night May 03, 2010

Powered by Coppermine Photo Gallery